What I am going to show you is the watts being produced off of the 26gauge coil winding. The current is produce by a collapse of the magnetic field around the coil. SETUP: Pulse motor running off of a relay and reed switch that is all. The wires off of the 26 awg coil go to a bridge rectifier to the 2200uf50v capacitor and to a light bulb. I hooked it up to a light bulb to show a load. As you can see the motor is only using 12.15v @ 68 milliamp = .83watts. Off the 26gauge wire (no electricity going to it) as you can see 7.6v @ 165ma = 1.3 watts out! My theory is that the magnets on the pulse motor are pushing current out as the field collapses. MAGNETS ARE FUEL! Thanks for watching...
Ciao
Todd
P.S. I am not even capturing the back emf going to the pulsing side of the coil :)
Kiss my
Categories